The Radiance Multi-Trigger Harness was designed specifically for the original Rigid Industries Radiance light bar. Equipped with two independent circuits for an easy install, circuit one is designed for higher amperage and utilizes a relay to power the primary LEDs on the Radiance light bar; while circuit two is designed for low amperage and has no relay for the backlighting circuit on the Radiance. The Radiance Multi-Trigger Harness also comes standard with two separate backlit LED rocker switches (red and blue), so each circuit can be used independently. The Radiance Multi-Trigger Harness makes installation of your Rigid Industries Radiance as simple and clean as possible.

Kit Includes:
- Wiring harness
- Toggle switches

Two independent circuits
Circuit 1 is designed for higher amperage and utilizes a relay to power the primary LEDs
Circuit 2 is designed for low amperage/no relay for backlighting circuit
Standard lengths from battery, switch and light
Two backlit LED rocker switches included for independent on/off of primary LEDs and backlighting
Three connectors with built-in heat shrink ends to be used for splicing in the pigtail
Integrated fuse holder to protect both circuits
Estimated installation time: 1-2 hours

Rigid Industries Radiance Multi-Trigger Harness