Product Description
Anderson Composites Type-OE Carbon Fiber Hood (Bronco 2021+)
- Mounts with OE hardware, hinges, and latch
- Vacuum infused process with 3K, 2x2 twill carbon fiber cloth, gloss finish
- Carbon fiber hood (A side) bonded to fiberglass "skeleton" (B side)
- Heat shield required.
- Requires hood pins for safety reasons.
- Hoods are hand crafted and weigh approximately 26.3 lbs. (stock hood weighs 35 lbs.)
Notes:
** PLEASE ALLOW A LEAD TIME OF 1-2 WEEKS FOR PRODUCTION AND SHIPPING
*** Items sold by Anderson Composites may not be legal for street use in all states or countries. It is the buyer’s responsibility to comply with applicable state or country laws. Buyer understands that due to strict U.S. Federal and State safety crash guidelines, Anderson Composites is not responsible or liable for any damages or possible injuries incurred upon possible accidents due to driver error, incorrect installations, bad judgment, or act of nature, etc. All products are intended for off-highway uses only, and should be used for their intended purposes only. Anderson Composites does not take responsibility over buyer installation, modification, and unusual stress of the products. Anderson Composites will not be held liable for anything other than the sale or exchange of said part and will not incur any other costs. The buyer assumes all responsibilities for determining the suitability of the products. Anderson Composites is not responsible for any damages incurred either directly or indirectly on the vehicles or operators/passengers within the vehicles.
